4
For Professional Technical Support call 1-844-242-2475
TOOLS REQUIRED
MATERIALS REQUIRED (NOT INCLUDED)
Discharge tee
Pipe
Threaded adapter
Elbow
Ball valve
Check valve
Union
SPECIFICATIONS
POWER SUPPLY
115V,60HZ,20Amp circuit
LIQUID TEMP. RANGE
32°F to95°F (0°- 35°C)
DISCHARGE
1in.NPT
SUCTION
1in. NPT
WATER LEVEL
25 ft.
INSTALLATION
CAUTION
: Risk of flooding. Be sure that all plumbing and fittings are rated to withstand the system pressure which you
expect the pump to generate.
NOTE
: Installation of a low pressure safety cutoff switch on the pump discharge is recommended (and may be required
by your local code) to shut off the power in case of low discharge pressure (caused by broken pipe, etc.).
A
．
Shallow Well Installation (For 0-25 ft. well)
1.
Connect the suction pipe to the pump inlet.(
Figure 1 )
2.
Prime the pump (Figure 2).
3.
Connect the pump outlet to the water system in your house (Figure 3).
4.
Plug the pump into 115V GFCI outlet to operate refer to OPERATION section on page 7.
Figure 1 Figure 2 Figure 3
Phillips
Screwdriver
Flathead
Screwdriver
Thread Tape
Tape Measure
Safety goggles
Hacksaw
PVC glue
Pipe wrench
