K Tool International KTI-XD63214 Owner'S Manual Download Page 2

KTI-XD63214/KTI-XD63221/KTI-XD63224 

 

rev. 01/13/21

This is the safety alert symbol. It is used to alert you to 
potential personal injury hazards. Obey all safety messages 
that follow this symbol to avoid possible injury or death.

 

             

IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING

BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING 
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.

It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the device 
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact 
an authorized K-Tool International repair center for replacements. If the operator is not fluent in English, the product and safety instructions shall be  
read to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator 
comprehends its contents.

THE NATURE OF HAZARDOUS SITUATIONS

The use of bottle jacks is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of intelligence, care, and 
common sense. It is essential to have personnel involved in the use and operation of the jack who are careful, competent, trained, and qualified in the safe 
operation of the jack and its proper use when servicing motor vehicles and their components. Examples of hazards are dropping, tipping or slipping of loads 
caused primarily by improperly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose 
for which it was not intended.

METHODS TO AVOID HAZARDOUS SITUATIONS

 

•  Read, study, understand and follow all instructions before operating this device.

 

•  Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid,  

 

 

  or unstable due to loose or missing components. Make corrections before using.

 

•  Lift only at points of the vehicle as specified by the vehicle manufacturer.

 

•  User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.

 

•  Do not exceed rated capacity.

 • 

No persons should be under vehicle when jack is in use.

 

•  This is a lifting device only. Immediately after lifting, support the vehicle with appropriate means.

 

•  No alterations shall be made to this product.

 

•  Use only on a hard level surface capable of supporting load.

 

•  Do not move or dolly vehicle while on jack.

 

•  Always lower the jack slowly and carefully.

 

•  Do not use saddle adaptors or saddle extenders between the stock lifting saddle and the load.

 

•  Center load on saddle. Be sure setup is stable before working on vehicle.

 

•  Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.

 WARNING: 

This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer  

 

and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS

Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,  
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could 
cause accidents resulting in serious or fatal personal injury and/or property damage.

WARNING: Indicates a hazardous situation 
which, if not avoided, could result in death 
or serious injury.

WARNING

WARNING

WARNING

WARNING

WARNING

Summary of Contents for KTI-XD63214

















Reviews: