Page 12
Programming
Easy, voice prompted programming directs the entry of feature
settings and plays back the information entered for confirmation.
Programming is done via the built-in keypad, or remotely by any
touch-tone telephone.
NOTE: A 9 VDC battery is required for programming using the
built-in keypad.
NOTE: Be sure prompt has completed before entering next
command.
NOTE: If there is no input within 9 seconds of an input request,
the unit will prompt, “Enter star, then program feature number”.
On-Site Programming:
1.
Connect 9 VDC battery to header on phone circuit board.
2.
Set
ONLINE/PROG
switch to
PROG
and wait for tone.
3.
Enter Program Mode (see below).
4.
Follow the instructions listed for each individual feature you wish
to set or change (see pages 12 - 15).
5.
Exit Program Mode (see page 15).
6.
Set
ONLINE/PROG
switch to
ONLINE
.
7.
Disconnect 9 VDC battery from phone circuit board.
Remote Programming:
1.
Call into the K-Phone ET401 Emergency Speakerphone.
2.
Once the call is answered, Enter Program Mode (see below).
3.
Follow the instructions listed for each individual feature you wish
to set or change (see pages 12 - 15).
4.
Exit Program Mode (see page 15).
5.
When finished, enter “ * # ” (star pound) once to exit program
mode, then press “ * # ” (star pound) a second time to shut it off.
Enter Program Mode
Activity
Enter
Voice Prompt
Enter Program Mode
* 7
"Enter Security Code"
Enter four digit Security Code
1 2 3 4
(Factory
Default)
"Enter star then Program
Feature number"
Summary of Contents for ET401A
Page 2: ...Page 2...
