K-Stove® is a brand of DMS-Europe BV
NL-3641AR-2 The Netherlands
26
The device is protected against excess current by a main fuse (on the rear of the device),
The following is a list of main components and their functions
IGNITER
The STOVE comes equipped with an automatic igniter for lighting the fuel when the stove is in
feeding and lighting mode.
VACCUM SWITCH
The STOVE has s vacuum switch located behind the left door, fastened to the base. If a low
pressure is created in the firebox by a leak, opening the front door, a blocked flue, or unsealed ash
drawer(some model), the vacuum switch will sense it and cause the stove to go into a shutdown
mode by showing E5.
AUGER AND AUGER MOTOR
The 2 RPM auger motor turns the auger, lifting pellets up the auger tube. The pellets are then
dropped down a tube and into the firepot. The auger motor is controlled by the control board.
PROTECT TEMPERATURE SENSOR TO AVOID
OVERHEATING
A safety temperature switch switches the stove off automatically if it overheats,. After the
stove has cooled down meanwhile it shows E6. Whether the heating operation is continued or
not depends on the remaining embers in the fire pan. After you remove the Error Code by
"Okay button" , If re-ignition does not occur when the fuel supply recommences, then the out
of operation program (cleaning , lag phase) is carried out. According to the pre-set mode the
stove must be re-started.
CAUTION: If overheating has occurred then maintenance or cleaning work must
be carried out.
EXHUASTED TEMPERATURE SENSOR FUNCTION AS
LOW TEMPERATURE
SWITCH OFF
If the stove cools down below a minimum temperature, then the stove will switch off. This
switch off can also occur if pre-heating is too slow.
