Note : The quality of the duct should meet the local law and fire prevention standards
8' aluminum flex duct can the hood directly or 6 ' aluminum flex duct connect to
and tight .
Connect the aluminum flex duct to ductwork, wrap with aluminum tape to make all joints secure
hood body by converter
STEP 8 : CONNECT ALUMINUM FLEX DUCT AND DUCTWORK
Converter
OR
8'aluminum flex duct
TIP (optional):
beneath the cabinet and flush with the front of the cabinet.
since the hood is heavy, a cabinet or a car jack is highly recommended.
Lift the hood up and have it placed below the cabinet. Make sure to center the hood
STEP 3: PREPARE DUCTWORK & SINGLE OUTLET
Make sure you have a 15amp, 120V, 60Hz, single outlet on the left or right of the duct pipe
(usually is on ¼ of cabinet width).
Make sure duct pipe is ready to hook up to the range hood before beginning installation (8”
diameter duct, and roof or wall cap, depending on where you will be venting your hood)
STEP 5: CREATE ACCESS
Create or cut access opening for electrical wire and hood exhaust under the cabinet
STEP 6: ATTACH THE HOOD
STEP 4: ATTACH 2-INCH WIDE WOOD FILLER STRIPS
For installing under the cabinet with recessed bottom, attach 2-inch wide wood filler strips
From inside of the hood, use “hex bit extension”
place 1 ¼” provided screw into each key hole (A) OR
predrilled-holes (B) and secure to cabinet bottom.
There are 8 holes (4 keyholes & 4 predrilled-holes)
available. You can use either key or predrilled-hole
as long as a minimum of 1 screw at each corner of
hood body.
STEP 7A: SECURE THE HOOD TO BOTTOM CABINET
STEP 7A: SECURE THE HOOD TO BOTTOM CABINET
!
11.
Connect the exhaust on the hood to the ductwork above. Use
6'aluminum flex duct
11.
