Installation, Programming and Operation Manual
27
www.krain.com |
INSTALLING A 4 STATION MODULE
INSTALLING A 14 STATION MODULE
The PRO EX 2.0 controller is supplied with a factory installed four
station module and can be expanded up to 16 stations by use of
additional four station expansion modules.
1. Connect the module ribbon cable to the main enclosure (Fig.
1) by gently pushing the ribbon connector straight onto the
connector post. Module terminals should be facing towards
the center of the enclosure.
2. Slide module under the tab (Fig. 2) labeled with the station
numbers.
3. Pushing module into position (Fig. 3), use the pre-installed
screw to secure the module fully.
NOTE
: DO NOT over tighten the screw. The screw should only
be turned enough to hold the module snug to the enclosure.
The PRO EX 2.0 controller is supplied with a factory installed four station
module and can be expanded up to 16 stations by use of additional four
station expansion modules.
1. Connect the module ribbon cable to the main enclosure (Fig. 4) by
gently pushing the ribbon connector straight onto the connector post.
Module terminals should be facing towards the center of the enclosure.
2. Slide module under the tab (Fig. 5) labeled with the station numbers.
3. Pushing module into position (Fig. 6), use the pre-installed screw to
secure the module fully.
NOTE: DO NOT overtighten the screw. The screw should only be turned
enough to hold the module snug to the enclosure.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
