2) Taking the audio line out from the cable slot as
shown
below if you want
to use the product.
Remarks:
Please don’t push the 3.5 mm plug into the buckle directly when you reel
the audio line.
Please don’t pull the3.5mm plug out from the buckle directly when you
take out the audio line.
The audio line should be push in or pull out by sliding as above shown to
avoid the damage of the buckle.
3.Turning on/off the receiver
Function
Operation
LED
indicator
Prompt tone
Turning on
Press and hold MFB
button for 3
～
4
seconds
Blue LED is
on for 1
second
Four raise tone
Turning off
Press and hold MFB
button for 3
～
4
seconds
Red LED is
on for 1
second
Four fall tone
Remark:
In order to save power
,
the receiver will turn off automatically if
no devices can be connected after 5 minutes.
3
4.Pairing with Bluetooth devices
1) How to enter pairing mode
Function
Operation
LED
indicator
Prompt tone
Entering
pairing
mode
Ensure the receiver
is turned off and then
press and hold MFB
button for 6
～
7
seconds .
Red and blue
LED flashes
alternately
Two raise tone
Remark:
The pairing mode will last 2 minutes, the receiver BTR017N will
switch to standby mode automatically if no devices can be connected within
2 minutes.
2)Pairing with Bluetooth mobile phone
Prior to using the receiver for the first time, you have to pair it with a
Bluetooth-enabled cell phone. The general pairing procedures are as
follows:
(1) Place the receiver and Bluetooth mobile phone where they are easily
viewable by no more than 1 meter apart;
(2) Enter the receiver’s pairing mode (please refer to “How to enter pairing
mode);
(3) Activate your mobile phone’s Bluetooth function and set your mobile
phone to search for Bluetooth devices within range, and select “BTR017N”
from the list of devices shown. After successful connecting, blue LED of
receiver flashes twice every 4 seconds.
Remarks:
After successful pairing, the receiver and the mobile phone will
remember each other, they will no need to re-pair next time. Every time
the receiver is turned on, it will connect to the last connected devices
automatically.
Every time the receiver is turned on, and if it doesn’t connect to any
devices, short press MFB button once, the receiver will connect to the
last connected device.
When the receiver and the mobile phone are out of effective range and
disconnected, they can connect to each other automatically once going
back to effective range.
4
