29
2740T TRASHCUTTER OPERATOR & SAFETY MANUAL
A F T E R D E L I V E R Y C H E C K L I S T
1. Check all pivot pins are fastened and anchor bolts are correctly
2. tensioned. Follow tension specification.
pg 17
3. Before mounting wheel to machine, check all hub and rim
contact surfaces are undamaged and free of paint, dirt and
grease.
Pg 17
4. Lubricate wheel studs with standard viscosity oil.
Pg 17
5. Tension wheel nuts for torque specifications.
Pg 17
6. Check tires are inflated.
Pg 17
7. Ensure all appropriate safety decals are securely attached to
machine.
Pgs 12-15
8. Check hydraulic system is fully primed.
pg 19
9. Check all safety mechanisms are in place and operating
correctly.
10. Lubricate heavy rear roller bearings. this page
11. Instruction manual has been stored with machine.
TYRE SAFETY & PRESSURES
•
Always cage tyres before seating beads.
•
Never exceed a stated pressure when seating beads.
•
Do not attempt to mount a tyre unless you have the suitable
equipment & experienced personnel.
•
Inflating tyres can be dangerous. Always stand to the side when
inflating.
•
Load ratings of replacement tires should meet or exceed weight
requirements.
•
Correct tire pressure is 90PSI/ 620KPA
•
Before mounting wheel to machine, check all hub & rim contact
surfaces are undamaged & free of paint, dirt & grease.
•
Lubricate wheel stubs with standard viscosity oil.
•
Tension wheel nuts to 320ft Ilbs / 433nm.
•
For field operation: Re-tension afterst, 5th, then
•
every 50 hours of operation.
•
For road travel re-tension first 3miles (5kms), 10miles (15kms),
and thereafter at 25miles (40km) intervals
.
COULTER GANG ASSEMBLY
INSTRUCTIONS
•
Follow exploded view for assembly
•
NB when re-tensioning spindle nuts always loosen U-bolts
on one bearing arm to allow for side movement & re-tighten.
COULTER GANG SERVICE SCHEDULE
Torque Table
Spindle Nuts
Coulter Bolts
1st Assembly
1100
ft/Ibs
50
ft/Ibs
5hrs Operation
1100
ft/Ibs
50
ft/Ibs
10
hrs Operation
1100
ft/Ibs
50
ft/Ibs
Every 50 hrs
1100
ft/Ibs
50
ft/Ibs
TYRE PRESSURE
Centre:
90PSI / 620KPA
Wing Wheels (both)
75PSI / 517KPA
Wheel Nut Tension:
320ft lbs / 433nm
Bearing Arm
WARNING
Wheel bearings:
•
Grease wheel bearings every 20 hours of operation.
•
Dimantle and repack with grease annually.
Figure 33
Figure 34
Figure 35
Figure 36
Coulter bolt Spindle nut
Figure 37
new 2740 trashcutter op & safety manual.indd 29
new 2740 trashcutter op & safety manual.indd 29
6/12/2019 7:07:06 PM
6/12/2019 7:07:06 PM
