K-Line CROP CADET SG60T, Operating & Safety Manual

Page: 21 / 48

21
SG60 SEEDER CROP CADET OPERATOR & SAFETY MANUAL
• Always cage tyres before seating beads.
• Never exceed stated pressures when
seating beads.
• Do not attempt to mount a tyre unless
you have the suitable equipment and
experienced personnel.
• Inflating tires can be dangerous. Always
stand to the side when inflating.
• Failure to comply could result in serious
injury or death.
• Load ratings of replacement tyres
should meet or exceed weight
requirements.
• Correct pressure is 90PSI/413KPA
(Centre)
• Before mounting wheel to machine,
check all hub and rim contact surfaces
are undamaged and free of paint, dirt
and grease.
• Lubricate wheel stubs with standard
viscosity oil.
• Tension wheel nuts to 350ft lbs/
474nm.
• For field operation: Re-tension after
1st, 5th, then every 50 hrs of operation.
• For road travel re-tension first 3 miles
(5kms), 10 miles (15kms), & thereafter
at 25 miles (40kms) intervals.
SERVICING PROCEDURES
TYRE PRESSURE
Centre:
90PSI/413KPA
Wheel Nut Tension:
350ft lbs /474nm
Tyre Pressures When Fitted With Standard
22.5 Inch Tyres
When optional flotation tyres are fitted
use tyre pressures stated on the tyre. If
no pressure stated use 50/55 PSI.
Figure 12
Figure 13
Figure 14
TYRE SAFETY & PRESSURES
(IF WHEELS FITTED)