K-array Redline KMT21, User Manual

Page: 23 / 28

REV. A
KMT21
23
11. SPECIFICATIONS
Acoustics
Speakers power
handling
1800 w
(EAS)
Maximum power 2800 w
1
Impedance 4Ω
Frequency range 30Hz - 150 Hz +/- 3dB (preset dependent)
SPL 1W/1mt 102 dB
2
Maximum SPL 132 dB continuous - 138 dB peak
Coverage
Omni
Crossover
Type DSP controlled
Frequency 150 Hz maximum (preset dependent)
Transducers
1 x 21” Neodymium speakers with 4”
voice coil
Audio Input
Analog
Connectors
2 male + 2 female 3-pin balanced XLR
Digital
Connectors
1 male + 1 female 3-pin XLR
Audio powered Output
Connector Female Speakon
Wiring
Pin1+= CH1+ Pin1= CH1- Pin2+= N.C.
Pin2= N.C.
Remote control Input
Connectors 1 male + 1 female XLR parallel
1 USB B Jack serial converter
Power Input
Connectors 2 x PowerCon IN/OUT
Amplifiers
Type 1 modules class D - DSP controlled
Subwoofer power 2400 Watt 3 @4Ω
Speaker power
output
2400 Watt
3
@4Ω
Protection
Dynamic limiter, over current, over temp,
short circuits
AC power
Operating range Dual voltage auto-selection
85-268 V 50/60 Hz
Consumption 670 VA
Minimum
operation voltage
95 Vac - 195 Vac
Maximum
operation voltage
125 Vac - 205 Vac
Physical
Dimensions
55.5 x 55.5 x 77.7 cm
(21.85” x 21.85” x 30.59”)
Weight 49 Kg (108.03 lbs)
Notes for data
1. Maximum RMS applicable power for a musical signal, the reference signal is the one proposed by EIAJ
standard.
2. Measured @4 mt then scaled @1 mt
3. Amplifier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the
amplifier will produce into the nominal load impedance.
New materials and design are introduced into existing products without previous notice. Present systems
may differ in some respects from those presented in this brochure.
KMT21