18
Getting Started
Figure 2-5: Module with Wall Mount Apparatus
2.5 Installing the USB-61210 Module
2.5.1
Connecting the USB-61210 Module
1. Turn on your computer.
2. Connect the USB-61210 module to one USB 2.0 port on your
computer using the included USB cable.
3. The first time the USB-61210 module is connected, a New
Hardware message appears. It will take around 6 seconds to
load the firmware. When loading is complete, the LED indica
-
tor on the rear of the USB DAQ module changes from amber
to green and the New Hardware message closes.
4. The USB-61210 module can now be located in the hardware
Device Manager, listed as
JYTEK USBDAQ 61210 Device
as
shown.
WARNING:
The appropriate driver must be installed before you can connect the
USB DAQ to your computer system. Refer to Section 1.9: Driver Sup
port for Windows for driver support information.
Summary of Contents for USB-61210
