Stereo Audio System for Your iPod
V10M10_IM_EN_10192006
www.i-Luv.com
- 14 -
OPERATIONAL INSTRUCTIONS
Using the Alarm Function
1.
To preview the alarm time, press the
ALARM 1
or
ALARM 2
buttons once.
2.
To activate or deactivate the alarm, press the
ALARM 1
or
ALARM 2
buttons once more.
3.
To snooze, press the
SNOOZE / DIMMER
button on the i177 (or on Remote Control), following the sounding of the alarm. The alarm will then shut off
and will sound again in approximately 9 minutes. You will have the opportunity to repeat this cycle many times during a 1 hour allotted alarm cycle.
4.
To turn the alarm off, press the
POWER OFF
button on the i177 (or the
POWER ON/OFF
button on the Remote Control). If all settings remain the
same, the alarm will turn on the following day at the same time. When the alarm is not turned off after it sounds, it will then play for approximately 60
minutes and turn off automatically. This cycle will repeat every 24 hours unless the controls are changed.
5.
To prevent the alarm from coming on daily, press the
ALARM 1
or
ALARM 2
buttons and set to off. Both the Alarm Icon and Wake-to icon will
disappear to signal that the alarm is deactivated.
Notes on Alarm Function:
•
Set your iPod to the repeat mode if you’ve selected
Wake To iPod,
and your iPod has less than one hour of songs.
•
If you have selected the
Wake To iPod
setting, yet no iPod is present or there is no music on the iPod at the alarm time, the i177 will automatically
switch to the buzzer mode.
•
In order to wake to your iPod, it must be appropriately placed in the built-in universal dock and powered off. If it is in the play mode no alarm will sound.
•
In the event of a power outage or if AC power is disconnected, when the i177 is powered by the Backup Battery, the alarm will NOT sound and time
and date will not be displayed. Time and date settings, however, will be temporarily saved.
Adjusting the Brightness of LCD Screen
To adjust the brightness of the LCD screen, press the
SNOOZE / DIMMER
button during normal operation. Each press will change the brightness level of
the LCD screen.
