XV-S300BK/XV-S332SL/XV-S402SL/XV-S403SG
7
SECTION 2
Disassembly method
There is a part different from the photograph
according to the model and the destination though
explains this disassembly method by using XV-S403SG for
Australia.
2.1 Main body
2.1.1
Removing the top cover (see Fig.2-1)
(1) Remove the two screws
A
attaching the top cover
on both sides of the body.
(2) Remove the three screws
B
attaching the top
cover on the back of the body.
(3) Remove the top cover from the body by lifting
the rear part of the top cover.
ATTENTION:
Do not break the front panel tab fitted to the top cover.
Fig.2-1
2.1.2
Removing the mechanism assembly(see Fig.2-2,2-3)
• Prior to performing the following procedure, remove the top cover .
• There is no need to remove the front panel assembly.
(1) Remove the three screws
C
attaching the mechanism
assembly on the bottom chassis.
(2) The servo control board is removed from the connector CN961
and CN701 connected with the main board respectively.
(3) Remove the mechanism assembly by lifting the rear part
of the mechanism assembly.
Fig.2-2
Fig.2-3
2.1.3
Removing the servo control board (see Fig.2-4)
• Prior to performing the following procedure, remove
the top cover and mechanism assembly.
(1) Disconnect the card wire from connector CN201 and
CN202 on the servo control board respectively.
(2) Disconnect the flexible wire from connector CN101 on the
servo control board from pick-up.
< ATTENTION >
At this time, please extract the wire after short-circuit-
ed of two places on the w ire in part a with solder.
Please remove the solder two places of part a after
connecting the wire with CN101 when reassembling.
(3) Two places in hook
b
are removed, the servo control
board is lifted, and it is removed.
Fig.2-4
A x 2
B
B
B
C
CN702
CN703
Main board
Mechanism assembly
C
C
CN701
CN961
Servo control board
Main board
Mechanism
assembly
Hook b
Hook b
Servo control
board
CN202
CN101
CN201
Part a