JVC XV-N420B, Service Manual

Page: 10 / 51

1-10 (No.YD054)
3.1.4 Removing the tray(See Figure 6, Figure 7)
• Prior to performing the following procedure, remove the mech-
anism assembly.
(1) Insert a kind of screwdriver in a hole located in the right
side of mechanism assembly, and push a lever until it can-
not be inserted any further.
(2) A tray is made to slide ahead.
(3) Remove the two screws
F attaching the shaft guide.
Fig.6
Fig.7
3.1.5 Removing the rear panel (See Figure 8 )
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the five screws G attaching the rear panel.
(2) Disconnect the power cord from connector P901 on the
main board
Fig.8
Tray
Push
F
Tray
F
Shaft guide
Main board
G G
P901