Page 12
GENERAL INFORMATIONS
COMPU LINK remote
control system
The COMPU LINK Remote Control System controls relative
operations between components automatically and facilitates
various operations.
This is a system originated and developed by JVC for facilitating
various system operations.
The following is a brief explanation of this system:
Automatic source selection
When the supplied COMPU LINK cord is utilized to connect this unit to
others equipped with COMPU LINK jacks, switching-in of each system
component can be performed with a single touch on the source
selector button located on a JVC amplifier or receiver.
When selection is carried out in this manner, the corresponding unit will
automatically start operation.
Upon pressing of the play button, the source selector of the amplifier
or receiver changes automatically. When a new unit is switched in, the
previously selected component stops operation within five seconds.
Synchronized recording
Synchronized recording refers to the process in which a JVC cassette
deck starts recording, synchronized with this unit. Synchronized
recording is carried out as follows:
1.
Set the cassette deck to the recording pause mode in accordance
with its instructions.
2.
To record only certain tracks, program the tracks in any order, as
desired.
3.
Press the
3
/
8
PLAY/ PAUSE button on the front panel of this unit.
The cassette deck automatically starts recording, synchronized
with this unit.
Notes
÷
Synchronized recording stops automatically when this unit stops
playback.
÷
To cancel synchronized recording, press the
7
STOP button of this
unit or the cassette deck.
÷
To properly operate the synchronized recording, the buttons/con-
trols other than POWER,
7
STOP and OPEN do not function.
÷
If the recording pause mode is set on the cassette deck by pressing
the
8
PAUSE button after pressing the
¶
REC and
3
PLAY buttons
simultaneously, synchronized recording is not possible. For details,
refer to the instructions for the cassette deck.
Automatic power on/off function
This function is to control the power on/off of the receiver/amplifier or
this unit respectively as the following.
÷
When this unit enters playback mode, the power of the receiver or
amplifier is turned on.
÷
When the source selector of the receiver/amplifier is set to CD
function mode, the power of this unit is turned on.
Notes
÷
Abnormal operation may result if the power supply of the component(s)
is interrupted. If this happens, you must start over again.
÷
Ensure that the COMPU LINK jacks of the each component are
connected with the supplied COMPU LINK cord. Also, be sure to
fully read the instructions for each component.
÷
When the power of the amplifier or receiver is switched off, this unit
is also turned off automatically.
