13
Set the camera in the following procedure.
Preparation Procedure
Step 1 Connection/Installation
Firstly, make a hole in the ceiling, followed by connecting the power cable, LAN
cable or alarm signal cable to the terminal of the ceiling mount of this camera.
Next, attach the camera to the ceiling. Do not forget to attach the safety wire.
Step 2 Network Settings
Install the software, set the network for this camera as well as using the "VN-
C655U Setup Tool", and register the connected camera with the "V.Networks
Controller".
Step 3 Setting Using the V.Networks Controller
Perform settings for Auto Pan, Auto Patrol, Auto Trace, Image Quality and Alarm
using the "V. Networks Controller" software that has been installed.
Step 4 Operating Using the V.Networks Controller
The "V. Networks Controller" can also be used to perform recording/playback
operations.
☞
Page 14
☞
Page 23
☞
Page 54
☞
Page 78
●
In a system where more than 1 VN-C655 is used, turn on the power for a VN-C655
first, followed by setting the camera until "2-3 Setting IP Address for this Camera
Using the 'VN-C655U Setup Tool' " is completed. Upon doing so, turn on a second
camera and perform setting in the same way. Perform the same procedure for
subsequent cameras.
(
☞
Page 18)
Step 5 Operating Using a Web Browser
Operation is possible via a web browser.
☞
Page 85
C655(B)_p2-22
05.3.16, 1:20 PM
13
