25
Memo
：
●
In a system where multiple units of VN-
C215VP4U are used, turn on the power of
only 1 unit to configure the IP address
settings via the Internet Explorer. Upon doing
so, turn on the power of the second unit and
configure accordingly. Configure the camera
settings using the same procedure.
●
Whenever duplication of IP addresses
occurs, check that there is only one VN-
C215VP4U under the same LAN
environment and wait for at least 10 minutes.
Access to VN-C215VP4U may be denied
unless you restore the power supply of all
network devices under the same LAN
environment.
●
To use AA-P700 in the power supply unit,
connect one unit of this product. Also refer to
the AA-P700 instruction manual.
To mount the camera to the base at a location
insulated from the ground, connect DC12 V-
(Black) cable with the base GND cable (Purple).
Warning
The rated power of this product is DC12 V.
Make sure to use it with the correct voltage.
Supplying a power different from the rated
value may result in failures and in the worst
scenario, smoking and fire.
Base GND cable connection
Base GND cable
(Purple)
Solder or crimp
Insulation tape
DC12 V- cable
(Black)
Base
Wind the waterproof tape
