9
Troubleshooting
If you have a problem with this System, check this list for a possible solution before calling for service.
Power
Power does not come on.
The power cord is not inserted securely. Plug it in securely.
=
The unit suddenly turns off.
Auto power save function is on. Refer to “Activating/deactivating APS
=
(Auto Power Save)” in “Basic operation.”
Remote control
The remote control does not work.
Pull out the insulation sheet.
=
Sunlight is shining directly on the remote sensor. Hide the remote
=
sensor from direct sunlight.
The path between the remote control and the remote sensor on the
=
front panel is blocked.
Point the remote control at the remote sensor on the front panel.
=
Signals cannot reach the remote sensor. Move closer to the unit.
=
The battery is exhausted. Replace the battery.
=
The remote control of the TV does not work.
If you installed the unit in front of the TV, connect the TV remote pass
=
through cable (supplied).
External components
No sound can be heard when DIGITAL 1 or
DIGITAL 2 is selected as a source.
Check the output setting of the connected digital components. Set the
=
output setting to PCM signal. (Refer “Specifications” on page 10 for
more information.)
iPod
iPod cannot be connected firmly.
Check to see whether the connector between iPod and the unit is not
=
damaged, and connect it.
iPod does not provide sound.
iPod is not properly connected. Remove iPod from the unit, and then
=
connect it again.
iPod cannot be charged.
iPod is not properly connected. Remove iPod from the unit, and then
=
connect it again. After connecting iPod, turn on the power again.
EN_TH-LB2[E]f.indd 9
EN_TH-LB2[E]f.indd 9
12/28/11 9:12:09 AM
12/28/11 9:12:09 AM
