1-16 (No.MB108)
3.3.10 Removing the spindle motor board
(See Figs.13 and 14)
• Prior to performing the following procedures, remove the DVD
servo board, clamper base and DVD traverse mechanism as-
sembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the feed motor wire that is soldered to the spin-
dle motor board. (See Fig.13)
(2) From the bottom side of the DVD traverse mechanism as-
sembly, remove the three screws
G
attaching the spindle
motor board. (See Fig.14)
Fig.13
Fig.14
Remove the solders.
DVD traverse mechanism assembly
Spindle motor board
Feed motor
wire
G
G
DVD traverse mechanism assembly
