24
Adjusting Dolby Surround
You can adjust the following settings while activating Dolby
Surround.
It is recommended that you make adjustments from your actual
listening point while listening to reproduced sounds.
– Output balance for the front speakers
– Output balance for the rear speakers
– Output level for the rear speakers*
– Output level for the subwoofer
• When Dolby 3 Stereo is activated, you cannot adjust the rear
speakers.
* The adjustment is separately memorized for Digital Multichannel
Surround (Dolby Digital and DTS Digital Surround), and for
Dolby Pro Logic.
• Dolby Surround cannot be used with DSP modes. Once one of
Dolby Surround is activated, DSP modes in use will be canceled.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
3
again.
1
Press AUX to select the external
component as the source.
2
Start playing a source encoded with Dolby
Surround.
3
Press PRO LOGIC repeatedly on the
remote control to select Dolby Pro
Logic or Dolby 3 Stereo.
The PRO LOGIC indicator lights up on the display.
• Each time you press the button, the indication changes as
follows:
Now, you are ready to start adjustments.
• To adjust the output balance for the front speakers and the rear
speakers, go to the next step.
• To adjust the output level for the center speaker, the rear speakers,
and the subwoofer, go to step
5
on the next page.
4
To adjust the output balance for the front
speakers and the rear speakers
1) Press SOUND repeatedly until one of
the following adjustment indications
appears on the display.
• Each time you press the button, the adjustment indication
on the display changes as follows:
00 F
(Front)
00
: To adjust the output balance for the front
speakers.
00 R
(Rear)
00
: To adjust the output balance for the rear
speakers.
• When selecting “3 STEREO,” you cannot adjust the output
balance for the rear speakers.
• “00 F 00” and “00 R 00” are the initial settings (the output
balances are at the center position). If you have already
changed the setting, another value will appear.
2) Press
3
or
2
to adjust the
output balance.
3
: Decreases the left speaker
output, or restores the right
speaker output.
2
: Decreases the right speaker
output, or restores the left
speaker output.
• Each output balance changes from
OFF (silence), –06 (most reduction) to 00 (no reduction).
3) Repeat 1) and 2) for setting the other speakers.
PRO LOGIC
PRO LOGIC
3 STEREO
STEREO
(canceled)
00 F 00
00 R 00
CEN
Normal indication
(canceled)
SW
REAR
SOUND
ENTER
AUX
D.R.C
Activating Dynamic Range Compression
You can enjoy a powerful sound even at a low volume level by
compressing the dynamic range (difference between the maximum
and minimum sounds).
• This function takes effect only when Dolby Digital is activated.
From the remote control ONLY:
Press D.R.C.
• Each time you press the button, the dynamic range
compression mode alternates between on and off.
Select “DRC ON” while watching the DVD at night. (You can
obtain a powerful sound at a low volume.)
TO BE CONTINUED ON THE NEXT PAGE
EN20-26TH-A30[J]12.pm6
02.5.22, 7:26 PM
24