42
EN
IN F-1
+
POWER
STOP/EJECT
(
7
/
0
)
1
2
REW ( )
FF ( )
PRO HD SYSTEM
PRO HD System
Playback
This PRO HD system can perform playback of the D-VHS tape
recorded by the MPEG2-TS signal.
This VCR can check the tape condition during playback (and
recording), and realizes the best possible pictures.
Please refer to next page, when you playback the
tape on which the password was set up.
1
Load a D-VHS cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
●
The VCR turns on automatically.
●
The tape will run for a few seconds while the
VCR searches for the tape number. If the tape
number is found, it will be shown on the TV
screen if “SUPERIMPOSE” is set to “ON”
(
墌
pg. 59).
●
The counter is reset automatically, however, it
is not completely reset to “0:00:00”.
●
If the cassette’s record safety tab has been
removed, playback begins automatically.
2
Start playback
Press
PLAY (
3
)
.
●
Tape speed is automatically detected.
To stop playback
Press
STOP (
7
)
on the Remote or
STOP/EJECT
(
7
/
0
)
on the front panel.
To rewind the tape (when it is not running)
Press
REW (
1
)
.
To fast-forward (when it is not running)
Press
FF (
¡
)
.
To eject the tape
Press
STOP/EJECT (
7
/
0
)
on the front panel when the
tape is not running.
●
You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press
POWER
.
VCR
TV
CABLE
/DBS
POWER
REW(
1
)
2
FF(
¡
)
STOP(
7
)
●
Turn on the VCR and the TV, and select the AV
mode on the TV.
●
Set the
VCR/TV/CABLE/DBS
selector on the
Remote to “VCR”.
VD400U-EN42-49
03.7.18, 1:07 PM
42
