10
Enhance your audio system
You can use this receiver as the pre-amplifier (control amplifier)
when you connect power amplifiers to the PREOUT jacks on the
rear panel, using cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
Rear view
About the FRONT 2 SPEAKERS terminals
The FRONT 2 SPEAKERS terminals can be used as follows:
• To connect another pair of the front speakers.
• To connect only one pairs of the speakers and to drive them using
two amplifiers built in this receiver.
If the speakers connected are of the bi-wiring connection type, you
can connect the speakers as illustrated below. (You can use either
front speaker terminals for high frequency or for low frequency
terminals.)
To use the speaker with the above connection,
see “
w
Setting the
Speakers 2 Usage—SPEAKER 2” on page 37.
• When this connection is used, you cannot use the surround back
speakers. (In this case, no sounds come out of the SURR BACK
PREOUT jacks.)
Connecting a subwoofer
You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the
SUBWOOFER PREOUT jack on the rear panel, using a cable with
RCA pin plugs (not supplied).
L
R
PREOUT
SURR
BACK
SUB
WOOFER
SURR
FRONT
CENTER
R
L
R
L
R
L
R
L
R
L
R
L
R
L
Power amplifier
Left front speaker
Right front speaker
Power amplifier
Right surround
speaker
Left surround
speaker
Power amplifier
Power amplifier
Left / Right
surround back speakers
Center speaker
Left Front speaker
Right Front speaker
Rear view
RIGHT
LEFT
+
–
CAUTION :
SPEAKER
IMPEDANCE
FRONT 1 SPEAKERS
FRONT 2 SPEAKERS
RIGHT
LEFT
CENTER
SPEAKER
8
16
FRONT 1 AND 2:
4
16
FRONT 1 OR 2:
HIGH
LOW
HIGH
LOW
Rear view
L
R
PREOUT
SURR
BACK
SUB
WOOFER
SURR
FRONT
CENTER
Powered
subwoofer
EN01-17_RX-DP20VSL[B]f.pm5
03.5.21, 17:24
10
