JVC RX-D301S, Service Manual

Page: 9 / 79

(No.MB383)1-9
3.1.3 Removing the rear panel
(See Fig.5)
• Remove the top cover.
(1) From the back side of the main body, remove the strain re-
lief from the rear panel in the direction of the arrow and re-
move the power cord.
(2) Remove the twenty-nine screws F attaching the rear panel.
(3) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
Fig.5
3.1.4 Removing the tuner
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the card
wire from the connector CN1 on the tuner.
(2) From the back side of the main body, remove the two
screws G attaching the tuner to the rear panel and take out
the tuner.
3.1.5 Removing the subwoofer board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN524 on the subwoofer board.
(2) From the back side of the main body, remove the screw H
attaching the subwoofer board to the rear panel and take
out the subwoofer board.
3.1.6 Removing the compulink board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN565 on the compulink board.
(2) From the back side of the main body, remove the screw J
attaching the compulink board to the rear panel and take
out the compulink board.
3.1.7 Removing the front video board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, remove the tie band
bundling the wires.
Reference:
After reassembling, bundle the wires with the new tie
band as before.
(2) Disconnect the wire from the connector CN662 on the vol-
ume board
(3) From the back side of the main body, remove the two
screws K .
(4) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
Fig.6
Strain relief
F
Rear panel
Power cord
F
F
J
Tuner Volume board
CN524
Rear panel
G K H
Rear panel
Subwoofer board
Front video board
CN1
CN565
Tie band
CN662
Coaxial connector
Nut and washer
Compulink board