JVC RX-8012PSL, Service Manual

Page: 3 / 72

RX-8012PSL
1-3
Remove the four screws A attaching the top cover
on both sides of the body.
Remove the three screws B on the back of the body.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
1.
2.
3.
Disassembly method
Removing the top cover (See Fig.1)
Prior to performing the following procedure, remove
the top cover.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
Remove the thirty six screws E attaching the each
board to the rear panel.
Remove the three screws F attaching the rear panel
on the back of the body.
1.
2.
3.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
Cut off the tie bands.
Disconnect the harness from the connector CN416
(on the video audio board), CN206 (on the video
board) and CN244 (on the S video board) (see fig.8).
Disconnect the card wire from the connector CN400
on the audio board and CN402 on the power supply
board.
Remove the three screws C which fix the upper
surface of the front panel, and four screws D which fix
the bottom.
Detach the front panel assembly toward the front.
Remove the screw P attaching the bracket for
headphone jack and remove the earth wire (see fig.
19).
1.
2.
3.
4.
5.
6.
Removing the front panel assembly
(See Fig.2 and 3)
Fig.1
Fig.2
Fig.3
Fig.4
A
2
B
Top cover
C
C
Power
supply board
Audio
board
CN400
Main
board
E
F
E
F
F
Cord stopper
Front panel assembly
Front panel assembly
D
Rear panel
T
Tie band
E E E
E