(No.MB207)1-21
3.3.2 Removing the sensor board / tray motor
(See Fig.44~47)
• Prior to performing the following procedure, remove the CD
tray.
(1) Release the two tabs attaching the sensor board on the un-
der side of the DC tray.
(2) Disconnect the wire from connector on the sensor board.
(3) Pull out the spacer attaching the turn table at the part
m
.
(4) Push the tab of part
m
inward to release the turn table
from the CD tray.
(5) Push the tab of part
n
inward to release the gear from the
CD tray.
(6) On the upper side of the CD tray, extend the tab p attach-
ing the tray motor and remove the tray motor in the direc-
tion of the arrow.
Fig.46
Fig.47
CD Tray
Gear
Turn table
Tab
p
Tray motor
