MX-G70
1-8
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
Disconnect the card wire from connector CN1 on the
tuner board on the right side of the body.
Remove the plastic rivet fixing the tuner board.
Remove the two screws
F
on the back of the body.
1.
2.
3.
Removing the tuner board
(See Fig.11 and 12)
Prior to performing the following procedure, remove
the metal cover and the CD changer mechanism
assembly.
Remove the screw
G
attaching the rear cover on the
back of the body.
Push each tab of the four joints
b
in the direction of
the arrow and release.
Remove the twelve screws
F
and two screws
F'
(Only US,UW ver.) attaching the rear panel.
Release the joints
c
on each lower side of the rear
panel using a screwdriver and remove the rear panel
backward.
1.
2.
3.
4.
Removing the rear cover / rear panel
(See Fig.12 to 15)
Note : Remove the tuner board in case of necessity.
(Refer to Fig.16)
Fig.11
Fig.12
Fig.13
Fig.14
Fig.15
CN1
Plastic rivet
Tuner board
Rear panel
Rear panel
G
F
Joint
b
Joint
b
Rear cover
Rear panel
F
F
F
Joint
c
Joint
c
Rear panel
Rear panel
F
(Only US,UW ver. )
F'
