JVC MC-8200LU, Service Manual

Page: 8 / 71

3. Grasp the grip to remove the magazine toward you. 6. Remove the drive from the rear.
2.1.4 Removing the Drive
1. Open the door. (Refer to 2.1.2.)
2. Remove the rear panel (DH). (Refer to 2.1.8.)
3. Disconnect the two connector cables from the drive.
4. Disconnect all the SCSI cables from all the drives and the
SCSI PCB. (When removing the drive in the uppermost slot
among the currently mounted drives, disconnect the cable
connected to the uppermost drive only.)
5. Remove the screw
1
located on the side of the drive (door
panel side).
2.1.5 Removing the Center Panel
1. Open the door. (Refer to 2.1.2.)
2. Remove the panel. (Refer to 2.1.2.)
3. Remove the six screws
2
to remove the center panel.
4. When loading the magazine, insert the magazine gently until
it clicks.
Note:
Center panel must be removed when removing the car-
rier mechanism.
Grip
SCSI cable Connector cable
1
Photo shows situation when removing the Drive 2
Photo shows situation when removing the Drive 2
2
6 screws
2-4