3. Remove the screw
@
and pull the SCSI PCB toward you
until the connector at the right sides are exposed, then dis-
connect the two connectors from the chassis side.
4. Remove the SCSI PCB by pulling it toward you.
5. When mounting the SCSI PCB, insert it so that the PCB
bracket passes under the guide rails.
2.1.13 Removing the Mail Slot
1. Open the door. (Refer to 1.1.2.)
2. Remove the side panel. (Refer to 1.1.7.)
3. Remove the #2 magazine. (Refer to 1.1.3.)
4. Insert your hand into the #2 slot and gently push the tray of
the mail slot. Pay attention not to push the tray forcibly for it
could damage the gear teeth.
6. Remove the eight screws
$
to remove the front panel of
the main unit.
Connector cable
Bracket
Mail slot panel
13
Guide
5. Gently pull out the mail slot tray toward you and push the
guide to the main unit side. Remove the screws
#
and pull
out the mail slot panel by sliding it toward the left.
8. Remove the mail slot from the front of the main unit.
7. Disconnect the connector cable on the mail CN PCB, and
remove the two screws
%
.
14
14
Connector cable
15
2-8
Summary of Contents for MC-8200LU
