JVC MC-8100LU, Instructions Manual

Page: 19 / 130

E18
6. MAIL SLOT
CAUTION
Do not load or eject a disc before the mail slot has stopped completely.
It may not only damage the disc but also cause the equipment to malfunction because of excessive force being applied
during opening and closing.
E X P O R T D O N E
P U S H L O A D K E Y
MODE SELECT LOAD/EJECT
POWER
ENTER
1 2 3
4 5 6
7 8 9
0
6-1. Disc loading
Disc loading/ejection method
When a tray is transported to the mail slot under the control of
the host computer or the import/export operation
(
a see page E19), the mail slot opens automatically when the
transportation has been completed.
1.
Place a disc gently on the tray with a label surface facing up-
wards.
(To remove a disc from the tray, hold the disc by the center
hole and the outer edge which is accessible near the notched
section on the front side of the tray.)
CAUTION
• Never use a damaged and/or warped disc or a disc with an attached label. It will lead to a malfunction of the equipment.
• If you are going to use a disc from a different drive, please check the drive specifications carefully before using it.
(Some drives may not be able to read the disc.)
(At the same time, the equipment may not be able to read the disc which has been written and deleted in a different drive.)
• Note that some double-sided discs do not provide a distinction between the top and bottom sides. Take special care
when removing/loading these discs from/in the MC-8100LU.
• In order to prevent a malfunction or failure, do not place two or more discs on a single tray.
CAUTION
• A disc may become impossible to write/read due
to dust, fingerprints, scratches, etc. adhering to the
disc surface. Please handle it carefully.
Take special care in handling the DVD-RAM/R discs
because they are extremely vulnerable to scratches
and contamination.
2.
Press the LOAD/EJECT key.
(The mail slot closes.)
• Now you can repeat the open/close operations alternately
by pressing the LOAD/EJECT key provided that the mail slot
transportation operation has not started yet.
• While the carrier is in operation, pressing the LOAD/EJECT
key will not start the open/close operations.
Label surface
(With a single-sided disc)
Note:
Media compatible with the MC-8100LU varies depending
on the installed drive type. For details, refer to the instruc-
tion manuals of the drives.
Note:
When using double-sided discs, handle them with special
care because they do not have a label on the surface.
MC-8100LU(E)-001B 04.10.29, 2:41 PM 18