19
Troubleshooting
“Dolby Digital selected!
No analogue audio
available”
z
When “Dolby Digital” is selected in “Digital Audio Output”, the
sound of a programme containing “Dolby Digital” signals cannot
be output from the TV or the audio system connected to the
AUDIO OUT terminal.
z
When the channel is changed, a message will be displayed for
a few seconds.
z
To listen with the TV or audio system
g
Select a language without “Dolby” from “Audio Selection”
g
Switch “Digital Audio Output” to “PCM”
“Services have
changed. Do you want
to Update PR list?”
z
Update the PR List (digital channels)
g
z
If the message appears even though PR List updating is not
required, set “Receiver Upgrade” to “Manual” to cancel the
reception test at midnight.
“Timer Starting Soon”
or “Reminder Changing
PR”
z
While watching TV, the message appears when a timer
programme is about to start, indicating that the channel will be
switched.
–
z
The message appears when you perform operations related to
the digital channels while a “Record” timer is in progress. Press
the “TV/DTV” button to continue recording or press the “OK”
button to stop the recording.
–
Messages
Actions
Page
z
Is the TV connected correctly to the aerial?
z
Change the direction of the indoor aerial.
z
Is there a digital channels transmission tower nearby?
g
Turn “Attenuator” to “On”.
z
Check digital channels signal with “Signal Check”.
z
If you still cannot watch the digital channels after following the
steps above, there may be a problem with your aerial or its
cable. Or, the signal may be too weak.
g
Consult your retailer
P. 38)
LT-42DP8BJ_Digital.book Page 19 Wednesday, July 4, 2007 2:47 PM
