JVC LT-19HA52U, Operating Instructions Manual

Page: 5 / 122

LT-19../LT-22.... LT-28....
EN
5
Carefully hold the base plate in position and secure it with screws.
three screws(M4x10mm)
To detach the base plate,perform these steps in reverse order.
For wall mounting,the base must be dismantled.To do this,remove screws from the back.
(LT-19.../LT-22...:100x100mm,LT-28...:200x100mm).
Remove the stand as one piece by reversing the fixing procedure described above.
You can refit the screws to the stand for safe keeping, but tighten them only slightly.
FIXING SCREWS
2x4mmx 5mm (TOP HOLES)
2x4mmx 5mm (BOTTOM HOLES)
Protect the screen and lay the TV flat on its face, on a stable table, with the stand foot clear of the
table edge.
To ensure a safe installation, please observe the following when hanging the television on a wall:
Warning: This operation requires two people.
Check that the wall can support the weight of the television set and a VESA-standard wall mount
assembly (not supplied).
Be sure to use only screws suitable for the material of the wall.
In case of any doubt please contact a qualified installer.
Beware of electrical cables, gas and water pipes in the wall.
Follow the instructions provided with the wall mount.
The set must be installed on a vertical wall.
Make sure that cables are placed so that there is no danger of tripping over them or damaging
them.
one screw(M4x20mm)
four screws(M4x8mm)
three screws(M3x15mm)
fit in
EN
Downloaded from www.vandenborre.be