JVC LST0601-001B, Startup Manual

Page: 27 / 32

19
䢇
Playing Back
1
Press the [PLAY] button
●
Playback starts from the date/time indicated in [Master
Time] of [Time Navigation].
●
Images are played back according to the angle of the
shuttle dial (x1/20, x1/5, x1, x2, x5, x10, x20).
䢇
Skipping
1
Press the [SKIP] button
●
The [SKIP] buttons have the following functions.
Memo :
●
“Sequence” indicates a certain block of images that are
recorded during motion detection.
●
Recorded images are stored in the database.
Note :
●
The [SKIP] buttons are only enabled when a camera has
been selected.
●
During simultaneous recording and playback, an A After
Database End B message may appear as playback
catches up with recording during playback near the
current time.
●
When recording is set to be triggered by motion/event ,
VR-N1600U/E will not start recording unless a motion/
event occurs. During playback near the current time,
however, the image that is not recorded will also be
played.
䢇
Stopping
1
Press the [STOP(PB)] button
●
Playback stops.
䢇
Enlarging the Display
●
Pressing a number that corresponds to the selected
camera enlarges the display.
●
To restore display to the normal size, press the number of
the camera with enlarged display.
Adjusting the Playback Speed (Jog/Shuttle
Playback)
You can adjust the playback speed by turning the jog dial/
shuttle dial on the front panel.
䡵
Shuttle Playback
●
Rotate the shuttle dial during playback or when playback
is paused to start fast forward, fast reverse or slow
playback.
Memo :
●
The playback speed that is indicated during fast forward or
fast reverse playback by rotating the shuttle dial is an
approximate value. The speed may differ depending on
the conditions, such as the playback mode (multi-view,
single view) and the recording mode (motion detection,
recorded frame rate).
䡵
Jog Playback
●
Rotate the jog dial to play back frame by frame.
●
Rotate the dial clockwise to play back a single frame in the
forward direction, and rotate the dial counterclockwise to
play back a single frame in the reverse direction.
●
Release the dial to pause the playback. However, when
frames are played back successively in the forward or
reverse direction, playback may continue momentarily
after the jog dial is released.
Note :
●
The jog dial is only enabled when a camera has been
selected.
●
When the playback speed is adjusted or when playing
back at high speed during recording, the frame rate of the
recording may decrease. Check the performance meter
while adjusting the playback speed to ensure that the
display does not turn red.
S Moves to the first image in the previous
sequence.
Moves to the oldest image in the database
of the selected camera when the button is
pressed and held down..
T Moves to the first image in the next
sequence. Moves to the first image in the
next sequence. When pressed and held
down, moves to the latest image in the
database for the selected camera.
NVR Viewer
[Master Time] area
[Time Navigation] Section
[Go To] Button
[Browse] Screen
still
x1
x2
x5
x10
x20
x1/20
x1/5
x1
x2
x5
x10
x20
x1/20
x1/5
REV FWD
Jog/Shuttle dial
Shuttle dial (Outside)
Jog dial (Inside)
VR-N1600_Startup_EN_001B.book Page 19 Thursday, August 20, 2009 1:10 PM