10
6
f
e
g
c d
b
a
3
1
h
2
4
5
Controls and Features
(cont.)
7
Rear panel
1
AC inlet
Power input connector. Connect the provided AC
power cord to an AC outlet (AC 120 V/AC 220 - 240
V, 50 Hz/60 Hz).
2
VIDEO terminals
a
VIDEO 1 terminals (BNC)
Input (IN) and output (OUT) terminals for the
composite signals.
• The IN and OUT terminals are bridge-
connected (auto termination).
• Use the AUDIO 1 terminal* for the audio
connection.
b
VIDEO 2 terminals (BNC)
Input (IN) and output (OUT) terminals for the
composite signals.
• The IN and OUT terminals are bridge-
connected (auto termination).
• Use the AUDIO 2 terminal* for the audio
connection.
c
AUDIO 1 terminal (pin jack)*
Input terminal for the analog audio signals.
• Use the VIDEO 1 terminal for the video
connection.
d
AUDIO 2 terminal (pin jack)*
Input terminal for the analog audio signals.
• Use the VIDEO 2 terminal for the video
connection.
3
REMOTE (external control) terminal (MAKE/
TRIGGER)
Terminals for controlling the monitor by an external
control.
• Enables the monitor to be controlled by short-
circuiting the pin terminal in this terminal or by
inputting the pulse signal.
+
“How to Use the External Control” on page 17
4
DVI-D terminals
e
AUDIO terminal (stereo mini jack)*
Input terminal for the analog audio signals.
NOTE:
• The built-in speaker of the monitor is monaural.
f
DVI-D terminal
Input terminal for the DVI-D signals.
NOTE:
• Use a DVI-D cable with two ferrite cores
(commercially available) to avoid electromagnetic
interference.
5
RGB terminals
g
AUDIO terminal (stereo mini jack)*
Input terminal for the analog audio signals.
NOTE:
• The built-in speaker of the monitor is monaural.
h
RGB terminal (D-sub 15-pin)
Input terminal for the analog RGB signals.
6
Security slot
Install a security wire to this slot.
* Equipped on LM-170A only
The illustration of the monitor is of LM-170A.
LM170A&150A-EN.indb 10
LM170A&150A-EN.indb 10
07.11.2 3:21:24 PM
07.11.2 3:21:24 PM
