46
CONNECTION/INSTALLATION
❏
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
·
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness connector to
the unit.
7
Install the unit in your car.
8
Reconnect the
·
battery.
9
Press the reset button.
10
Configure
<Initial Setup>
. (page 4)
Installing/removing the unit
❏
Installing the unit
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
❏
Installing the trim plate
Attach the trim plate (
2
).
2
❏
Removing the trim plate
1
Engage the catch pins on the extraction
key (
4
) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
4
2
Remove the upper two locations.
• The frame can be removed from the top side in
the same manner.
❏
Removing the unit
1
Remove the trim plate. (See the left
column.)
2
Insert the two extraction keys (
4
), then
pull them as illustrated so tat the unit can
be removed.
4
• Be careful to avoid injury from the catch pins on
the extraction key.
KW-V̲Mid̲E.indb 46
2014/01/27 15:13
Downloaded from www.vandenborre.be
