ENGLISH
31
Data Size:
B6L (182 mm x 128 mm)
Book Size:
B6L (182 mm x 128 mm)
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery’s negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car’s chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that comes into
contact with metal parts to protect the wires.
Caution
• For safety’s sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of
the speakers is lower than 50 W, change the
[AMP GAIN]
setting to avoid damaging the
speakers.
( 19)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle’s fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car’s chassis, then replace the old
fuse with one that has the same rating.
INSTALLATION/CONNECTION
Auxiliary
Frequency Response (±3 dB)
20 Hz — 20 kHz
Input Maximum Voltage
1 000 mV
Input Impedance
30 kΩ
Audio
Maximum Output Power
50 W × 4 or
50 W × 2 + 50 W × 1 (Subwoofer = 4 Ω)
Full Bandwidth Power
(at less than 1 % THD)
22 W × 4
Speaker Impedance
4 Ω — 8 Ω
Preout Level/Load
KW-R930BT:
CD/USB: 2 500 mV/10 kΩ load
KW-X830BT
:
USB: 2 500 mV/10 kΩ load
Preout Impedance
≤ 600 Ω
General
Operating Voltage
(10.5 V — 16 V allowable)
14.4 V
Maximum Current Consumption
10 A
Operating Temperature Range
–10°C — +60°C
Installation Size (W × H × D)
182 mm × 111 mm × 158 mm
Net Weight (includes Trimplate,
Mounting Sleeve)
KW-R930BT:
1.6 k
g
KW-X830BT:
1.2 k
g
Subject to change without notice.
SPECIFICATIONS
JS_JVC_KW_R930BT_E_EN_3.indd 31
JS_JVC_KW_R930BT_E_EN_3.indd 31
7/5/2017 10:59:04 AM
7/5/2017 10:59:04 AM
