KS-FX8
1-12 (No.49826)
Front panel assembly
Extension cord
EXTKSRT002-18P
Main board
Cassette mechanism
D
isassembly method
1. Remove the front panel assembly.
2. Remove the bottom cover.
3. Remove the front chassis assembly.
4. Remove the heat sink.
5. Remove the rear panel
6. Remove the main board.
7. Reattach the heat sink with the two screws D. (Refer to Disassembly method.)
8. Reattach the rear panel with the screw G. (Refer to Disassembly method.)
9. Reattach the front chassis assembly with the screw B. (Refer to Disassembly method.).
10. Reattach the front panel assembly.
11. Confirm that current is being carried by connecting an extension cord jig.
Note
Available to connect to the CJ701 connector when installing the front panel.
CAUTION :
Be sure to attach the heat sink and rear panel on the power amplifier IC and regulator IC
of a main board when supplying the power.
If voltage is applied without attaching those parts, the power amplifier IC and regulator IC
will be destroyed by heat.
1. We're advancing efforts to make our extension cords common for all car audio products.
Please use this type of extension cord as follows.
2. As a U-shape type top cover is employed, this type of extension cord is needed to check operation of the
mechanism assembly after disassembly.
3. Extension cord : EXTKSRT002-18P ( 18 pin extension cord ) For connection between mechanism assembly
and main board.
4. Check for mechanism driving section such as motor ,etc.
Information for using a car audio service jig
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
