JVC KD-G815, Service Manual

Page: 23 / 95

(No.MA170)1-23
3.2.13 Removing the select arm R / link plate
(See Figs.27 and 28)
• Prior to performing the following procedure, remove the top
plate assembly.
(1) Bring up the select arm R to release from the link plate
(joint a') and turn as shown in the figure to release the two
joints b' and joint c' .
(2) Move the link plate in the direction of the arrow to release
the joint d' . Remove the link plate spring at the same time.
REFERENCE:
Before removing the link plate, remove the mode sw..
Fig.27
Fig.28
3.2.14 Reattaching the Select arm R / link plate
(See Figs.29 and 30)
REFERENCE:
Reverse the above removing procedure.
(1) Reattach the link plate spring.
(2) Reattach the link plate to the link plate spring while joining
them at joint d' .
(3) Reattach the joint a' of the select arm R to the first peak of
the link plate while joining the two joints b' with the slots.
Then turn the select arm R as shown in the figure. The top
plate is joined to the joint c' .
CAUTION:
When reattaching the select arm R, check if the points e'
and f' are correctly fitted and if each part operates prop-
erly.
Fig.29
Fig.30
Ö±·²¬ ® Ô·²µ °´¿¬»
Ö±·²¬ ¾ù
Ö±·²¬ ¾ù
Ö±·²¬ ½ù
Í»´»½¬ ¿®³ Î
Ö±·²¬ ¿ù
̱° °´¿¬»
Ô·²µ °´¿¬»
Ô·²µ °´¿¬» -°®·²¹
Ö±·²¬ ¼ù
Í»´»½¬ ¿®³ Î
Ö±·²¬ ½ù
Ö±·²¬ ¼ù
Ô·²µ °´¿¬» -°®·²¹
Ö±·²¬ ¾ù
Ö±·²¬ ¾ù Ö±·²¬ ¿ù
Ô·²µ °´¿¬»
Ö±·²¬ ¿ù
б·²¬ »ù
б·²¬ ºù