4
INSTALLATION / CONNECTION
When using the optional stay
Install the unit at an angle of
less than 30˚.
Screw (option)
Stay (option)
Fire wall
Dashboard
*
Not supplied for this unit.
Flat type screws (M5
×
8 mm)
*
Flat type screws (M5
×
8 mm)
*
Bracket
*
Bracket
*
Removing the unit
In dash-mounting
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
Do the required electrical
connections.
Bend the appropriate tabs
to hold the sleeve firmly
in place.
When you stand the unit,
be careful not to damage
the fuse on the rear.
Purple
Front speaker (left)
Blue
Red
To an accessory terminal
in the fuse block
To a live terminal in the
fuse block connecting
to the car battery
(bypassing the ignition
switch) (constant 12 V)
Yellow
*
2
To the metallic body
or chassis of the car
Black
Ignition switch
15 A fuse
Fuse block
Rear speaker (left)
Rear speaker (right)
Front speaker (right)
White with black stripe
Rear ground terminal
Antenna
terminal
Gray with black stripe
Green
Gray
Green with black stripe
Purple with black stripe
White
ELECTRICAL CONNECTIONS
Connections without using the ISO connectors
INSTALLATION
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Connect only the front speakers if your
speaker system is two-speaker system.
Before connecting:
Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this
unit. The leads of the power cord and those of the connector from the car body may be different in color.
1
Cut the ISO connector.
2
Connect the colored leads of the power cord in the order specified in the illustration below.
3
Connect the antenna cord.
4
Finally connect the wiring harness to the unit.
To the automatic antenna if any
(250 mA max.)
E
F
B
D
H
G
A
C
N
J
I
K
M
L
P
O
• Connect the ISO connectors as illustrated.
From the car body
ISO connector of the supplied power cord
View from the lead side
You may need to modify the wiring of the supplied power cord as illustrated.
• Contact your authorized car dealer before installing this unit.
Original wiring
Modified wiring
1
Use modified wiring
2
if the unit does not turn on.
ISO connector
Y: Yellow
R: Red
Modified wiring
2
If your car is equipped with the ISO connector
For some VW/Audi or Opel (Vauxhall) automobile
PRECAUTIONS on power supply and speaker connections:
•
DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will
be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your
car.
*
1
Not supplied for this unit
*
2
Before checking the operation of this unit prior to installation, this
lead must be connected, otherwise the power cannot be turned on.
EN_KD-G246[UG]_2.indd 4
EN_KD-G246[UG]_2.indd 4
10/24/07 9:01:26 AM
10/24/07 9:01:26 AM
