background image

4

D

Other external component

CAUTION:

Before connecting the external components, make sure that the unit is turned off.

 

Connecting the external components

JVC CD changer

  Set “EXT IN” for the external input setting (See page 24

 

of the INSTRUCTIONS.)

  Set “CHANGER” for the external input setting (See page 24 of the INSTRUCTIONS.)

iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.

JVC CD changer, Apple iPod, or JVC D. player

F

E

Connecting the external amplifier

You can connect an amplifier to upgrade your car stereo system.
•  Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.

•  Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.

Rear speakers

JVC Amplifier

Remote lead

Y-connector 

*

3

Remote lead (blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

Front speakers

 

Required connections for DVD playback

Audio/video control amplifier or the decoder compatible with the 
multichannel digital sources

KV-MR9010

9-INCH WIDESCREEN MONITOR 

*

3

Digital optical cable 

*

3

Apple iPod

JVC D. player

CD changer jack

You can connect these components as illustrated below. The iPod or D. player can be connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for D. player).

Video cord 

*

3

or

or

Only for KD-DV5304/KD-DV5303

External component

*

3

  Not supplied for this unit.

*

4

  Signal cord (not supplied for this unit).

*

5

  Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*

6

  Connecting cord supplied for your CD changer.

*

7

  Line Input Adapter KS-U57 (not supplied for this unit).

*

8

  AUX Input Adapter KS-U58 (not supplied for this unit).

3.5 mm stereo mini plug

CD changer jack

External component

External component

or

Instal3-4_DV5304_002A_pre.indd   4

Instal3-4_DV5304_002A_pre.indd   4

12/5/06   11:23:58 AM

12/5/06   11:23:58 AM

Summary of Contents for KD-DV5304

Page 1: ...assis again after installation Notes Replace the fuse with one of the specified rating If the fuse blows frequently consult your JVC car audio dealer It is recommended to connect to the speakers with maximum power of more than 50 W both at the rear and at the front with an impedance of 4 Ω to 8 Ω If the maximum power is less than 50 W change AMP GAIN setting to prevent the speakers from being dama...

Page 2: ... 8 mm long screws If longer screws are used they could damage the unit Install the unit at an angle of less than 30 TROUBLESHOOTING The fuse blows Are the red and black leads connected correctly Power cannot be turned on Is the yellow lead connected No sound from the speakers Is the speaker output lead short circuited Sound is distorted Is the speaker output lead grounded Are the terminals of L an...

Page 3: ...rd 3 Finally connect the wiring harness to the unit 15 A fuse Black Blue with white stripe Red Yellow 2 To metallic body or chassis of the car Ignition switch Fuse block To an accessory terminal in the fuse block To the remote lead of other equipment 200 mA max To a live terminal in the fuse block connecting to the car battery bypassing the ignition switch constant 12 V 1 Not supplied for this uni...

Page 4: ...nna if any Front speakers Required connections for DVD playback Audio video control amplifier or the decoder compatible with the multichannel digital sources KV MR9010 9 INCH WIDESCREEN MONITOR 3 Digital optical cable 3 Apple iPod JVC D player CD changer jack You can connect these components as illustrated below The iPod or D player can be connected using an interface adapter not supplied KS PD100...

Reviews: