JVC CD changer /
AV1-IN
AV2-INPUT
4
Required connections for DVD playback /
D
Audio/video control amplifier or the decoder
compatible with the multichannel digital sources
KV-MR9010
9-INCH WIDESCREEN
MONITOR (not supplied)
Video cord (not supplied)
Stereo mini plug
RCA Pin plugs
Digital optical cable (not supplied)
DIGITAL OUT
See “About sounds reproduced
through the rear terminals.”
*
4
Only for KD-DV6108/KD-DV6105: To listen to disc playback sound while in Dual Zone operations (see page 32 of INSTRUCTIONS).
E
Connecting the external amplifiers /
Only for KD-DV6108/KD-DV6105
To the remote lead of other equipment or auto antenna if any
Y-connector (not supplied for this receiver) /
Remote lead/
*
5
Signal cord (not supplied for this receiver)
Front speakers
Rear speakers
JVC Amplifier
JVC Amplifier
JVC Amplifier
Subwoofer
Front speakers
Remote lead (Blue with white stripe)
*
6
Firmly attach the ground wire to the
metallic body or to the chassis of the
car—to the place not coated with paint
(if coated with paint, remove the paint
before attaching the wire). Failure
to do so may cause damage to the
receiver.
CAUTION /
• Before connecting the CD changer, make sure that the receiver is turned off.
*
7
Connecting cord supplied for your CD changer
F
Connecting the external components /
• Refer also to page 39 of the INSTRUCTIONS.
JVC CD changer
External component /
*
8
Line Input Adapter KS-U57 (not supplied for this receiver)
KS-U57
*
8
CD changer jack
External component
LINE IN
Set external input to “EXT IN” (See page 36 of the INSTRUCTIONS.)
Only for KD-DV5108/KD-DV5105
Only for KD-DV6108/KD-DV6105
External component
or /
Rear side
VIDEO OUT
When using JVC’s KV-MR9010
and KS-HP2, connect using a
conversioncable of this type (not
supplied).
2nd AUDIO OUT
*
1
*
1
Headphones (not supplied)
*
4
KS-HP2
Cordless headphones (not supplied)
*
4
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that
it can be controlled through this receiver.
•
For amplifier only:
–
Disconnect the speakers from this receiver, connect them to the amplifier. Leave the
speaker leads of this receiver unused.
– For KD-DV6108/KD-DV6105
:
The line output level of this receiver is kept high to maintain the hi-
fi sounds reproduced from this receiver. When connecting an external amplifier to this receiver,
turn down the gain control on the external amplifier to obtain the best performance from this
receiver.
Instal3-4_DV6108_004A.indd 5
12/21/04 10:11:09 PM