1-6 (No.HC027<Rev.001>)
(4) Disconnect the wires from each connector
CN13
,
CN21
on
the CODEC board.
(5) Remove the four screws
E
attaching the CODEC board,
and then remove it.
Fig.5
(6) Remove the four screws
F
attaching the SxS board, and
then remove it.
Fig.6
3.1.3 Removing the guide unit (See figure 7, figure 8, figure
9)
• Remove the SxS board.
(1) Remove the two screws
G
attaching the guide unit with
SxS board.
Fig.7
(2) Remove the guide unit from the SxS board by sliding the
guide unit to the direction of the arrow.
Fig.8
NOTE:
Attention at installation.
Fig.9
E
CN13
CN21
CODEC Board
E
NOTE:
Be careful not to damage the CN28 when
removing or attaching the CODEC board.
F
F
SxS Board
G
G
SxS Board
Guide unit
Come into contact
Locked surely
