1-14 (No.YD051)
3.2
Loading mechanism assembly
3.2.1 Removing the tray (See Figure 3-2a, Figure 3-2b, Figure 3-2c, Figure 3-2d, Figure 3-2e, Figure 3-2f)
(1) Push
a
of the slide cam on the hole in the right side of the
loading base by using a driver until it stops. (See Figure 3-
2a.)
(2) The tray comes out. Pull the tray in a front direction until it
stops.
(3) Remove the two screws
A
attaching the slide bracket. (See
Figure 3-2b.)
(4) Tilt the tray in a direction of the arrow around the point in
the left rear part of the tray. (See Figure 3-2c.)
(5) The rail of the tray is removed from
b
of the loading base.
Then, remove the tray upward. (See Figure 3-2d.)
Attaching the tray:
Engage
c
of the loading base to the projection of the tray while
tilting the tray to the left. Turn the tray in a direction of the ar-
row, and attach the slide bracket. (See Figure 3-2e.)
Note:
Prior to the procedure above, move the slide cam in a direction
of the arrow so that
d
of the slide cam can be inserted in
e
of
the tray. (See Figure 3-2f.)
Fig.3-2a
Fig.3-2b
Fig.3-2c
Fig.3-2d
Fig.3-2e
Fig.3-2f
Tray
Push
Loading base
Slide cam part
a
Tray
A
A
Slide bracket
Tray
The point in the left rear part
Loading base part
b
Rail of the tray
Projection of the tray
Projection of the tray
Loading base part
c
Slide cam
Part
d
Part
e
