EN
7
AUTO CH SET
PLEASE WAIT
START
FINISH
TV Screen
When Auto Set Up is completed, the lowest position
number will appear on the front display panel.
During Auto Set Up
"PLEASE WAIT" blinks on the screen and "Auto"
blinks on the front display panel.
NOTES:
●
If you perform Auto Set Up when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on
the screen. When this happens, make sure of the aerial connection and press
OK
; Auto Set Up will take place again.
●
If there is a power cut, or if you press
or
MENU
while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to
turn off the recorder power once and try again.
●
If you want to set the tuner manually such as to add or skip channels, to swap channel positions, or to fine-tune channels,
Z
pg. 27–29.
●
If no sound accompanies the picture on some channels that have been stored by Auto Set Up, the TV system setting for those
channels may be incorrect. Select the appropriate TV system for those channels.
Z
"TV System Selection – When you see the
picture but hear no audio" on page 29.
DO NOT press any button on the recorder or remote control while Auto Set Up is in progress.
SELECT TV SYSTEM
6
Press
PUSH JOG
%fi
to place the pointer next to the
appropriate TV system (refer to the table on the left).
START AUTO CHANNEL
SET
7
Press
OK
or
PUSH JOG
.
●
The Auto Set Up function scans all the channels that
are receivable by your recorder. It then automatically
assigns each receivable channels to the
TV PROG
buttons. It skips non-receivable channels.
●
As Auto Set Up progresses, the " " mark on the
screen moves from left to right. (See below.)
fi
Major Countries
TV System
Kuwait, U.A.E, Indonesia, Singapore,
Thailand, Malaysia, Iran, Saudi Arabia,
B/G
Egypt, Morocco, Lebanon, Iraq
China, Mongolia, Russia
D/K
Hong Kong
I
0
7
8
9
4
3
2
PUSH JOG
OK
