12
PLAYBACK (cont.)
Instant ReView
Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTES:
●
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
●
Turn on the TV and select the VIDEO channel (or AV mode).
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on, then
"
™
1" appears on screen and the recorder searches
for the index code indicating the start of the last timer-
recorded programme. Once it’s found, playback begins
automatically.
If you have, for example, 3 programmes and wish to
watch the first of the 3 programmes, press REVIEW
three times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTE:
Instant ReView is not possible while the recorder is in the Timer
mode.
Your video recorder can automatically play back the whole tape
20 times repeatedly.
Repeat Playback
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
●
"PLAY" on the display panel blinks slowly.
●
The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.
Intelligent Picture
To get a better picture when viewing tapes with noise such as
rental tapes. Useful for normal playback of SP(or LP)-mode
recorded tapes as well.
ACTIVATE INTELLIGENT
PICTURE
1
During playback or stop, press PICTURE.
●
The INTELLIGENT PICTURE indicator on the recorder
lights.
●
To turn it off, press PICTURE again.
●
Intelligent Picture is not effective during search, slow,
still, or frame-by-frame playback even though the
INTELLIGENT PICTURE indicator on the recorder
lights.
Tape Position Indicator
The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “
5
” in relation to “0”
(beginning) or “+” (end) shows you
where you are on the tape.
”O.S.D.” (
Z
pg. 5) must be set to
“ON”, or the indicator will not
appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
0
+
+
+
3
1:23:45
Summary of Contents for HR-J231SA
Page 31: ...31 MEMO ...