EN
23
ENTER SHOWVIEW
NUMBER
4
Press OK, and a cursor
appears above “GUIDE
PROG”. Then, using the
NUMBER keys, input the
ShowView number (found
in most TV listings) of a
program scheduled to be
broadcast on each station
on the list from step 1,
starting at the top. If you
enter the wrong number,
press CANCEL and input the correct number.
ENTER CHANNEL POSITION
NUMBER
4
5
Press OK and the display
under “TV PROG” begins
blinking.
If the blinking number
under “TV PROG” agrees
with the channel
position . . .
. . . press OK.
If the numbers do not agree . . .
. . . input the channel position using PUSH JOG
%fi
or
the NUMBER keys, then press OK.
●
If you input the ShowView number of a program that
has already aired, “ERROR” appears on screen for a
few seconds. Input the correct ShowView number.
●
Repeat steps 4 and 5 as necessary.
CLOSE MENU
6
Press CH SET and selection is complete.
If you already know the Guide Prog. number for a station . . .
1– After step 3, press PUSH JOG .
●
The GUIDE PROG number begins blinking.
2– Enter the Guide Prog. number using the NUMBER keys or
PUSH JOG
%fi
, then press PUSH JOG .
●
The TV PROG number begins blinking.
3– Enter the channel position using the NUMBER keys or
PUSH JOG
%fi
, then press PUSH JOG .
●
Repeat 2 and 3 as necessary.
4– Press CH SET.
When entering a ShowView
number for ARD
When Using A Satellite
Tuner
Preparation
1– Connect the satellite tuner to the AV2 IN/DECODER
connector on the rear of your recorder.
2– Set the AV2 SELECT switch to "AV2".
To Record Satellite Broadcasts . . .
1– Select the appropriate channel on the satellite tuner.
2– Press NUMBER key "0" to set your recorder's input mode to
"AUX2".
3– Start recording (
Z
pg. 16, steps 3 – 6).
To Record Satellite Broadcasts Using ShowView Timer
Recording . . .
1– Perform Guide Prog. Number setting.
●
In step 5 in the left column, press NUMBER key "0" to set
"TV PROG" to "AUX2".
2– Perform ShowView Timer Recording (
Z
pg. 24).
To Record Satellite Broadcasts Using Regular Timer Recording . . .
1– In step 6 on page 26, press TV PROG. +/– to set the channel
position to "AUX2".
NOTES:
●
When timer-recording a satellite programme, first set the
satellite tuner to the appropriate channel before the selected
programme begins and then set the satellite tuner's timer. If
your satellite tuner does not have a timer, leave it switched
on.
●
If your recorder's front panel VIDEO and/or AUDIO connec-
tors are being used, they take priority and "AUX2" cannot be
selected. Make sure no cables are connected to the front
panel connectors when performing this procedure.
12345
5
GUIDE PROG TV PROG
1
1
[0 – 9]
=
GUIDE PROG TV PROG
250
39
[
5∞
]
=
Satellite
Tuner
Satellite Antenna
Ex. 1
Ex. 2
AV2 IN/DECODER
AV2 SELECT Switch
%
%
%
Satellite
Tuner and
Decoder
Aerial or Cable
TV Receiver
