9
PRESET DOWNLOAD
SET THE TUNER CHANNELS BY DOWNLOADING FROM YOUR TV, CLOCK AND GUIDE PROGRAM
NUMBERS
When you connect the recorder and your TV via fully-wired 21-pin SCART cable (
Z
pg. 6), you can set the recorder's tuner channels
by downloading preset data from your TV instead of using the Auto Set Up function (
Z
pg. 8). After downloading is completed, the
recorder sets the clock and Guide Program numbers assigned by the VIDEO Plus+ system automatically.
For details, refer to the instruction manual for your TV.
NOTES:
●
In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program
number set.
●
If there is a power cut, or if you press
or
MENU
while downloading or set up is in progress, it will be interrupted; be sure to
turn off the recorder power once and try again from the beginning.
●
Auto clock may not function properly depending on reception conditions.
●
When you perform T-V LINK function, be sure to use fully-wired 21-pin SCART cable.
●
On this recorder, the characters available for station names (ID) are A–Z, 0–9, –,
*
, + and (space). The names of some
downloaded stations may differ from those on your TV (
Z
pg. 62).
ATTENTION
You can use this function only with a TV offering T-V Link, etc.*
* Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-wired 21-pin
SCART cable. The degree of compatibility and available functions may differ by system.
Before performing the following procedure, make sure that:
n
the TV aerial cable is connected to the recorder and a 21-pin SCART cable is connected between your TV and the recorder.
n
the mains power cord is plugged into the mains outlet.
n
batteries have been installed in the remote control.
2
If "Auto" appears on the display panel,
Press
%fi
to select "CH – –" and press
OK
or
#
. Preset position on the display panel
increases from "CH1";
do NOT press any button on the recorder
or remote control until the display panel
shows clock time, "(PR) 1" or
"– –:– –" as illustrated on page 10.
●
If you are using the on-screen display, the T-V
LINK screen will appear. Then the GUIDE
PROG SET screen will appear during Guide
Program number set.
●
If you press any button on the recorder or
remote control while downloading is in
progress, this process will be interrupted and
you will need to start again. See NOTES below.
T-V LINK
PLEASE WAIT
[MENU] : EXIT
GUIDE PROG SET
PLEASE WAIT
[MENU] : EXIT
1
2
3
4
5
6
7
8
9
1
2
1
2
3
– –:– –
0
3
4
4
1
Press
to turn on the recorder.
Summary of Contents for HM-DR10000EK
Page 79: ...MEMO ...