1-18 (No.86772)
3.2.5
ASSEMBLY/DISASSEMBLY OF [19] OP BLOCK ASSMBLY/[25] CCD BOARD ASSEMBLY
z
CAUTIONS
(1) Be careful in handling the CCD image sensor, OP LPF,
and lens etc., especially not to damage or soil their sur-
face.
If it is soiled with fingerprints, etc., gently clean it with
chamois or the cleaning cloth.
(2) When the CCD image sensor is shipped from the factory,
there are protection seals applied onto the transparent
glass. Leave the protector as it is, and take it off just be-
fore assembling the CCD image sensor to the OP block.
z
Disassembly procedure of OP BLOCK ASSEMBLY/CCD
BOARD ASSEMBLY
(1) Remove the three screws (1-3), and remove the OP
BRACKET ASSEMBLY.
(2) Unsolder the sixteen soldered parts (SD19) on the CCD
BOARD ASSEMBLY, and remove the CCD BOARD AS-
SEMBLY.
(3) Remove the two screws (4 and 5), and remove the CCD
BASE ASSEMBLY.
NOTE19a
In removing the CCD BASE ASSEMBLY, be careful in
handling a sheet and OP LPF since a sheet or OP LPF
is removed together with the CCD BASE ASSEMBLY.
NOTE19b
In replacing the CCD image sensor, donÅft remove
the CCD image sensor from the CCD BASE ASSEM-
BLY. Instead, replace the whole CCD BASE ASSEM-
BLY.
(4) Remove the sheet and OP LPF.
(5) Remove the two screws (6 and 7), and remove the MAIN
FRAME ASSEMBLY.
NOTE19c
When attaching OP LPF to the OP BLOCK ASSEM-
BLY, be careful about the attachment direction.
Fig.3-2-5
∗
0.147N·m (1.5kgf·cm)
∗
3
(S19a)
6
(S19b)
4
(S19b)
SD19
7
(S19b)
5
(S19b)
∗
1
(S19a)
∗
2
(S19a)
NOTE19a,b
CCD BOARD ASSEMBLY
SHEET
OP LPF
OP
SIDE
CCD
SIDE
OP LPF
NOTE19c
MAIN FRAME
OP BLOCK ASSEMBLY
OP BRACKET ASSEMBLY
CCD BASE ASSEMBLY
