JVC GR-FXM333, Instructions Manual

Page: 41 / 60

EN
41
PLA
YBACK
Basic Connections
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder’s power is off.
2
CONNECT CAMCORDER TO TV OR
VCR
Pull out the connector cover and open it.
Connect as shown in the illustration (
Z
pg. 40).
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3
CONNECT VCR OUTPUT TO TV
INPUT
Refer to your VCR’s instruction manual.
4
SUPPLY POWER
Turn on the camcorder, the VCR and the TV.
5
SELECT MODE
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack (
Z
pg. 5).
●
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to “CAMERA” (“AUTO”
or “PRO.”), then set your TV to the appropriate
input mode.
●
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
●
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
Tape Dubbing
1
CONNECT EQUIPMENT
Following the illustration on pg. 40, connect the
camcorder and the VCR.
2
PREPARE FOR DUBBING
Set the camcorder’s Power Switch to “PLAY”,
turn on the VCR’s power, and insert the
appropriate cassettes in the camcorder and the
VCR.
3
SELECT VCR MODE
Engage the VCR’s AUX and Record-Pause
modes.
4
FIND EDIT-IN POINT
Engage the camcorder’s Play mode to find a spot
just before the edit-in point. Once it is reached,
press PLAY/PAUSE (
4 / 6 ) on the camcorder.
5
START EDITING
Press PLAY/PAUSE (
4
/
6
) on the camcorder and
engage the VCR’s Record mode.
6
STOP EDITING TEMPORARILY
Engage the VCR’s Record-Pause mode and press
PLAY/PAUSE (
4
/
6
) on the camcorder.
7
EDIT MORE SEGMENTS
Repeat steps 4 through 6 for additional editing,
then stop the VCR and camcorder when
finished.