JVC GR-DVM5, Instructions Manual

Page: 36 / 92

36
EN
ON
OFF
32kHz
06
5S SCENE
BEEP / TALLY
FRAME PHOTO MODE
WIND CUT
SOUND MODE
ID NUMBER
OFF DEMO. MODE
RETURN 4
32kHz 48kHz
5S ANIM.
ON OFF
ON OFF
ON OFF
5SD
FRAME MULTI 4 MULTI 9
PIN-UP
FULL
PHOTO MODE
See pages 30 and 31.
SCENE (5-Second Mode) (
Z
pg. 28)
5S–Pressing START/STOP allows you to take a 5-
second “clip”. Press repeatedly for a succession of
short recordings.
5SD–If you record a 5-second clip within 5 minutes
after the previous one, the end of the old scene
dissolves and is replaced by the new scene over a
2-second period.
ANIM. (Animation)–Each time you press START/
STOP, a 1/8-second recording is taken. By using an
inanimate object and changing its position between
shots, you can record the subject as though it’s
moving.
• Animation is not available in the LP mode. If you
tried to record in the LP mode after setting ANIM.,
the recording mode indicator “LP” begins to blink,
and recording goes on in the SP mode.
NOTE:
During use of SCENE effect, focus (
Z
pg. 45) and
exposure control (
Z
pg. 46) enter Full Auto
operation.
BEEP/TALLY
The beep sounds when the power is turned on or
off, and at the beginning and end of recording.
Tally lamp lights up during recording.
ON–To activate the beep and tally lamp.
OFF–To turn off the beep and tally lamp.
This number is necessary when connecting
the camcorder to a computer [01 to 99].
WIND CUT
When activated, this mode helps cut down on noise
created by wind.
ON–When shooting in high winds, set to “ON” to
reduce noise.
•“
” appears.
•The quality of the sound will change. This is normal.
OFF–This function is disabled.
NOTE:
The Wind Cut mode is disabled during Full Auto
operation.
SOUND MODE
Sound signals can be sampled at 32 kHz or 48 kHz.
32 kHz–This setting enables recording of stereo
sound on four separate channels, and is recom-
mended for use when performing Audio Dubbing
with another digital camcorder.
48 kHz–This setting enables recording of stereo
sound on two separate channels.
NOTE:
A tape recorded at 48 kHz cannot be used for
Audio Dubbing with another digital camcorder.
DEMO. MODE (Demonstration Mode)
This setting demonstrates certain functions such as
P.AE/Effects (
Z
pg. 44), etc., and can be used to
confirm how these functions operate. When the
camcorder is turned off, “DEMO. MODE” is set to
“OFF”.
NOTE:
If a tape is in the camcorder, the Demo mode
cannot be turned on.
RECORDING
Advanced Features (Cont.)