42
EN
I T E M S
N O T E S
❍
Perform charging where the temperature is between 10°C and 35°C (50°F
and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for
charging. If the environment is too cold, charging may be incomplete.
❍
Charging times are for a fully discharged battery pack.
❍
Charging time varies according to the ambient temperature and the
status of the battery pack.
❍
To avoid interference with reception, do not use the AC Adapter near a
radio.
❍
Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
❍
The following operation stops charging or discharging:
•Set the Power Switch to “
”, “
” or “
”.
•Disconnect the AC Adapter from the camcorder.
•Unplug the AC Adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
❍
The date/time cannot be stored in memory if the built-in clock battery
runs out. Consult an authorized JVC dealer for replacement, or set the
date/time as necessary before you start shooting.
❍
When the Power Switch is set to “
” or “
” and the LCD monitor is
opened at an angle of 60 degrees or more, the LCD monitor switches
on and the viewfinder switches off automatically to save power
(models equipped with LCD monitor only).
❍
The cassette holder cannot be opened unless a power supply is attached.
❍
There may be a delay after you slide EJECT until the cassette holder
opens. Do not use force.
❍
The time required to calculate the remaining tape length, and the accuracy of
the calculation, may vary according to the type of tape used.
❍
The tape remaining time indicator is correct only if the correct tape
length has been selected (
Z
pg. 12).
❍
“TAPE END” appears when the tape reaches its end, and the power
goes off automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at its
end is loaded.
❍
If the Recording Start/Stop button is pressed after the Record-Standby
mode has continued for over 5 minutes, recording may not start
immediately.
❍
While shooting, sound is not heard from the speaker (models equipped
with LCD monitor only).
❍
The “TBC” indicator turns green (gray with a camcorder equipped with
a black/white viewfinder) while TBC is working.
❍
TBC does not work during still playback and shuttle search.
❍
The “TBC” indicator turns white while TBC is not operative.
❍
It may take a few seconds before TBC actually starts working.
❍
The picture may be distorted if the TBC mode is activated or
deactivated at the edit-in/-out points or when normal playback resumes
after still playback or shuttle search.
❍
If the playback picture is distorted when TBC is set to on, turn off TBC.
DETAILS
➪
Date/Time
Settings
(
Z
pg. 9)
➪
Power
(
Z
pg. 6)
➪
TBC
(Time Base
Corrector)
(
Z
pg. 31)
➪
Recording
(
Z
pg. 14, 15)
